Smart Technologies Parts Kit for SMART Board 560 Configuration And User's Manual page 67

Resetting the Lamp Timer
After you replace the lamp, reset the lamp timer.
To reset the lamp timer
1. Press the power button on the ECP or the remote control
turns solid green when the system starts.
2. To confirm that the lamp timer has been reset, access the service menu by pressing DOWN
UP , LEFT
Your lamp reset count increases by one.
3. Wait five minutes for the projector lamp to warm up.
4. Put the system into Idle mode by pressing the power button twice on the ECP or remote control. The power
button light on the ECP turns solid amber when the system is in Idle mode.
NOTE: The lamp may take up to 15 minutes to re-strike.
5. When you are ready to use the system, press the power button on the ECP to start the system.
99-00964-20 A0
, UP on the remote control. Select
Appendix B: Replacing Your UF55 Projector Lamp
to start the system. The ECP's power light
on the lamp. Select Lamp Hour Reset > Yes.
, UP ,
57