Smart Technologies Parts Kit for SMART Board 560 Configuration And User's Manual page 23

5. Adjust the physical size of the projected image to fit the interactive whiteboard.
a. If you haven't already done so, loosen the large wingnut on the top of the ball joint to allow the
projector to move backward and forward in the slot.
b. Move the projector backward or forward on the boom to make the image larger or smaller.
NOTE: During this step, you may need to tilt or turn the projector slightly to keep the image square.
6. Focus the projector using the focus lever (see Focusing the Image on page 14).
NOTE: You may need to repeat all steps in smaller increments in order to fine-tune the image.
7. Tighten the large wingnut on the top of the ball joint.
99-00964-20 A0 Installing Your UF55 Projector Parts Kit 13