Environmental Requirements - Smart Technologies Parts Kit for SMART Board 560 Configuration And User's Manual

Environmental Requirements

Before installing your UF55 projector parts kit, review the following environmental requirements.
• Never operate your projector immediately after moving it from a cold location to a warm
CAUTION
• At high altitudes, where the air is thin, the projector's cooling efficiency is reduced. Set the
• Do not place the projector in hot locations, such as near heating equipment. Doing so could
Environmental Requirement
Operating Temperature
Storage Temperature
Humidity
Water and Fluid Resistance
Dust and Scratching
Electrostatic Discharge (ESD)
Conducted and Radiated Emissions
6
location. When your projector is exposed to such a change in temperature, moisture might
condense on the lens and on crucial internal parts. Allow your projector to reach room
temperature before operation to prevent possible damage to your projector.
projector's fan mode to High in locations where the altitude is over 6000' (1828.8 m).
cause a malfunction and shorten the life of the projector.
Installing Your UF55 Projector Parts Kit
Parameter
• 41°F to 95°F (5°C to 35°C) from sea level to an altitude
up to 6000' (0 m to 1828.8 m)
• 41°F to 86°F (5°C to 30°C) from 6000' to 9800'
(1828.8 m to 2987 m)
-40°F to 122°F (-40°C to 50°C)
30% to 70% relative humidity, non-condensing
• Intended for indoor use. SMART Board interactive whiteboard
systems do not meet any salt-spray or water ingress
requirements.
• Don't pour or spray liquids directly on interactive whiteboard,
the projector or any of its sub-components. These liquids might
get into areas where they could damage sensitive electronic
components.
• For use in office and classroom environments
• Not for industrial use, where heavy dust and pollutants can
cause malfunctions or impaired operation
• Designed for pollution degree 1 (P1) as per EN61558-1, which
is defined as "No pollution or only dry non-conductive pollution"
• EN61000-4-2 severity level 4 for direct and indirect ESD
• No malfunction or damage up to 8 kV (both polarities)
with a 330 ohm, 150 pF probe (air discharge)
• Unmated connectors meet no malfunction or damage
up to 4 kV for direct (contact) discharge.
EN55022/CISPR 22, Class A
99-00964-20 A0