Smart Technologies Parts Kit for SMART Board 560 Configuration And User's Manual page 58

• If the lamp has shattered or burst, call an
WARNING
• The lamp used in the UF55 projector contains mercury. Recycle or dispose of it as
• Use only replacement lamps approved by SMART Technologies. Contact your
• Turn off the projector and wait 30 minutes for the lamp to cool completely before removing
• Never replace the lamp assembly with a previously used lamp assembly.
• Do not open or disassemble the projector as this may cause electric shock.
• Avoid turning off the projector during the lamp ignition phase as this may lead to premature
• This projector detects its own remaining lamp life. Replace the lamp when lamp life warning
• If you continue to use the projector after the replacement message appears, the lamp might
• Remove the projector from the projector's arm before servicing the lamp. Complete the
• Replacing the lamp in a boom-mounted projector might result in a fall or injury.
• Uncovering the lamp while the projector is mounted on a projector's arm might lead to
• Wear protective eyewear while changing the lamp. Failure to do so can cause injury or loss
• To prevent premature lamp failure or exposure to mercury, always handle the fragile lamp
• Cleaning a boom-mounted projector may result in a fall or injury.
48
Do not attempt to replace the lamp. Do not touch the glass fragments because they might
cause injury. Leave and then ventilate the area where the lamp shattered or burst. Wash
your hands thoroughly if you have come into contact with lamp debris. Thoroughly clean the
area around the projector, and discard any edible items placed in that area because they
may be contaminated.
hazardous waste, in accordance with local regulations.
authorized SMART reseller
the old lamp assembly.
lamp failure. Before turning the projector off, keep the lamp on for a minimum of 15 minutes
after turning it on to preserve the lamp life.
messages appears.
shatter or burst, scattering glass throughout the projector headWhen the lamp is
approaching the end of its life, the message "Lamp is approaching the end of its useful life in
full power operation" appears on the screen. Contact your
service center to change the lamp as soon as possible.
procedure described in this document before following the instructions included in your
replacement lamp box.
product damage or personal injury from falling pieces of glass if the lamp is broken.
of eyesight if the lamp shatters or bursts.
assembly with care. Use gloves when touching the lamp. Do not touch the lamp with
your fingers.
Appendix B: Replacing Your UF55 Projector Lamp
authorized SMART reseller
for replacement parts.
for instructions.
authorized SMART reseller
99-00964-20 A0
or