Smart Technologies Parts Kit for SMART Board 560 Configuration And User's Manual page 6

• Never operate your projector immediately after moving it from a cold location to a warm
CAUTION
• At high altitudes, where the air is thin, the projector's cooling efficiency is reduced. Set the
• Do not place in hot locations, such as near heating equipment. Doing so could cause a
• Before you clean the UF55 projector, put the system into Idle mode by pressing the power
• Do not allow liquids or commercial solvents of any kind to flow into the projector base or
• Cycling power to the projector repeatedly can lock or damage the interactive whiteboard
• Do not connect your serial cable directly to the projector's RS-232 serial interface. The
• You must connect the USB cable that came with your SMART Board interactive whiteboard
• Using the UF55 projector near a TV or radio may cause interference to the images or sound.
IMPORTANT
• If you have peripheral devices that do not use a 4-pin mini-DIN connector or an RCA
• Wipe the exterior of the projector using a lint-free cloth.
iv
location. When your projector is exposed to such a change in temperature, moisture may
condense on the lens and on crucial internal parts. Allow your projector to reach room
temperature before operation to prevent possible damage to your projector.
projector's fan mode to High in locations where the altitude is over 6000' (1828.8 m).
malfunction and shorten the life of the projector.
button twice on the ECP or remote, and allow the bulb to cool for 30 minutes.
head. Do not use spray cleaners or solvents near any part of the projector, as it may damage
or stain the projector.
system. After you turn off the system, wait at least 15 minutes for cooling before starting the
system.
extended control panel's (ECP's) RS-232 serial interface is the only recommended
connection point.
to a computer that has a USB compliant interface and that bears the USB logo. In addition,
the USB source computer must be compliant with CSA/UL/EN 60950 and bear the CE mark
and CSA and/or UL Mark(s) for CAS/UL 60950. This is for operating safety and to prevent
damage to the SMART Board interactive whiteboard.
If this happens, move the TV or radio away from the projector.
composite video jack, or if your device has an audio connection that does not use RCA
jacks, you may need to purchase third-party adapters.
Important Information 99-00964-20 A0