Connector Pin Assignment Table - Panasonic AKHCU200 Operating Instructions Manual

Connector pin assignment table

[COMMUNICATION]
JBY-25S-1A3F(LF)(SN) (J .S .T . Mfg . Co ., Ltd .)
Pin No . Signal
1 INCOM 1 OUT (H)
2 INCOM 1 OUT (C)
3 INCOM 1 (GND)
4 INCOM 1 IN (H)
5 INCOM 1 IN (C)
6 PGM IN (H)
7 PGM IN (C)
8 PGM IN (GND)
9 GND
10 NC
11 R TALLY IN(H)
12 R TALLY IN(C)
13 GND
14 INCOM 2 OUT (H)
15 INCOM 2 OUT (C)
16 INCOM 2 (GND)
17 INCOM 2 IN (H)
18 INCOM 2 IN (C)
19 NC
20 NC
21 NC
22 NC
23 NC
24 G TALLY IN (H)
25 G TALLY IN (C)
z Example of tally input connections
z
"TALLY switch" on the rear panel: MAKE
"TALLY switch" on the rear panel: V
38
Flow of signals
CCU → SYSTEM 0 dBm, 600 Ω (4W)/1 V [p-p] (RTS)
z Select "4W" or "RTS" and "INCOM1" or "INCOM2" with the "INCOM switches" on the
z
CCU → SYSTEM
rear panel .
[When "RTS" is set, terminate pins 1 and 3 of the connector using a terminating
resistor (200 Ω) .]
SYSTEM → CCU
SYSTEM → CCU
SYSTEM → CCU
0 dBm/–20 dBm, 600 Ω
z Select "0dB" or "20dB" for the GAIN PGM item on the INCOM/MIC screen
z
SYSTEM → CCU
(pages 21 and 31)
SYSTEM → CCU ON: Short/TTL(H)/24 V
SYSTEM → CCU
OFF: Open/TTL(L)/24 V
CCU → SYSTEM 0 dBm, 600 Ω (4W)/1 V [p-p] (RTS)
z Select "4W" or "RTS" and "INCOM1" or "INCOM2" with the "INCOM switches" on the
z
CCU → SYSTEM
rear panel .
[When "RTS" is set, terminate pins 14 and 16 of the connector using a terminating
resistor (200 Ω) .]
SYSTEM → CCU
SYSTEM → CCU
SYSTEM → CCU ON: Short/TTL(H)/24 V
SYSTEM → CCU
OFF: Open/TTL(L)/24 V
AK-HCU200
R TALLY IN (H)
G TALLY IN (H)
5 V
3.9 kΩ
R TALLY IN (C)
G TALLY IN (C)
12.4 kΩ
AK-HCU200
R TALLY IN (H)
G TALLY IN (H)
5 V
3.9 kΩ
R TALLY IN (C)
G TALLY IN (C)
12.4 kΩ
Remarks
 Refer to "Example of tally input connections" .
 Refer to "Example of tally input connections" .
(Max . current 20 mA)
(Max . current 20 mA)
or
(Max . voltage 24 V)
Voltage withstand: Max . 24 V DC
Current: Max . 20 mA