Table of Contents
Advertisement
Web settings
(Continued)
z SETTING2 Screen
z
indicates the factory default setting .
Setting
Item
value
FS DELAY
NORMAL
SHORT
HD BAR SELECT
FULL
BARS-1
ARIB
BARS-2
BARS-3
BARS-4
BARS-5
BARS-6
28
Remarks
Select the delay mode for the HD return
signals .
NORMAL:
Matches return signal input that does
not match the sync phase to the
phase of the camera by delaying it by
1 frame .
SHORT:
Sets the shortest delay . (5 H)
However, if the following conditions
are not met, it is delayed by
1 frame + 5H .
z HD signal
z
z The SD-HD V item in the HD/SD
z
PHASE screen is "ADVANCE" or
"0H_SD_DLAY"
z When output from this unit is used
z
as the return signal, the delay is
less than 3H
Select the color bar signals to be output
from the HD/SD SDI OUT connectors
and VBS connector when "BAR" has
been selected on the operation panel
of the ROP .
When they are output in VBS or SD
format, color bars in HD format are
output in the mode specified with
DOWNCONVERT MODE* .
FULL:
75 % full field color bar
BARS-1:
Color bar based on the SMPTE
standard
ARIB:
ARIB multi-format color bar
BARS-2:
Color bar based on the EIAJ standard
BARS-3:
Split field color bar
BARS-4:
75 % full field color bar placed in an
area with a 4:3 aspect ratio .
(Displayed 40 % gray outside the
area .)
BARS-5:
Color bar based on the SMPTE
standard that is placed in an area
with a 4:3 aspect ratio .
(Displayed 40 % gray outside the
area .)
BARS-6:
Color bar based on the EIAJ standard
that is placed in an area with a 4:3
aspect ratio .
(Displayed 40 % gray outside the
area .)
Setting
Item
value
HD BAR LPF
OFF
3TAP
5TAP
7TAP
9TAP
HD BAR USER1
75%WHITE
(ARIB)
100%WHITE
+I_SIGNAL
–I_SIGNAL
HD BAR USER2
0%BLACK
(ARIB)
+Q_SIGNAL
SETUP 7 .5%
ON
OFF
PATHO
ON
OFF
*: The DOWNCONVERT MODE setting can be configured by operating
the REMOTE OPERATION menu with the ROP .
For details, refer to Operating Instructions <Operations and Settings>
of AK-HRP200 .
Remarks
Select the filter through which to pass
the color bar signals to be output
from the HD/SD SDI OUT connectors
when BAR has been selected on the
operation panel of the ROP .
z A higher TAP value will ensure a
z
smooth rise and fall of the waveforms
and reduce both the overshoot and
undershoot .
Set user range 1 for when ARIB has
been selected as the HD BAR SELECT
setting .
This can be set when "ARIB" is selected
for the HD BAR SELECT item .
In the case of another setting, this is
disabled .
Set user range 2 for when ARIB has
been selected as the HD BAR SELECT
setting .
This can be set when "ARIB" is selected
for the HD BAR SELECT item .
In the case of another setting, this is
disabled .
Select whether to add the setup 7 .5 %
level to the SD signals to be output from
[OUT/PM] of the VBS connectors .
When the CCU MODE item is
"1080/50i", SETUP 7 .5% is disabled
even if you set it to "ON" .
Select ON/OFF for the pathological
signals .
Hide quick links:
Advertisement
Table of Contents
