Warning System; Warning Description Tables - Panasonic HPX300 - Camcorder - 1080p Operating Instructions Manual

Warning System

Warning Description Tables

If a problem is detected immediately after the power is turned on, or during operation, this will be indicated by the
WARNING lamp, lamps inside the viewfinder and a warning tone.
Warning LCD or viewfinder
Priority
type indication
SYSTEM ERROR
1 System error Cause indication *
blinking
Incorrect
TURN POWER OFF
2 P2 card
Blinks red
removal
LOW BATTERY Red
blinking, and the battery
The level bar blinks with
3 battery is the empty status. (This
exhauseted indication appears also
when MENU indications
have been turned OFF.)
FULL
P2
P2 card fully
4
Blinks red (appears only for
recorded
3 seconds in MCR mode.)
REC WARNING
Recording
5 Cause indication
error
red
Irregular TEMPORARY PAUSE
6 reference IRREGULAR FRM SIG
signal Blinks red.
Drop in
reception
quality of WIRELESS RF
7
wireless Blinks red
receiver
transmission
Warning
Tally lamp
lamp
Blinks 4 Blinks 4
Red times per times per
1
second second
Blinks 4 Blinks 4
times per times per
second second
Blinks 1 time
Lights
per second
Blinks 4
times per Lights after
second after completing
completion recording
of recording.
Blinks 4 Blinks 4
Blinks times per times per
*2
second second
Blinks 4 Blinks 4
times per times per
second second
Blinks 4
times per Blinks 4
second times per
(Recording second
only)
Warning description
Alarm
and recording/playback
tone
*6
operation
Continuous P2 microprocessor or control
tone failure. Operation stops.
A P2 card was removed
during access and card data
Continuous
was corrupted.
tone
Both access LEDs light
orange.
The battery is exhausted.
Recording and playback
Continuous
stop. The camera stops
tone
automatically when the
voltage drops.
Continuous
No more space on P2
tone after
cards left for recording.Stop
completing
recording.
*3
recording
Intermittent A recording error has
tone 4 occurred. The error may
times per terminate recording or let it
second continue.
*4
An irregular reference
signal input to GENLOCK IN
prevents normal recording
Intermittent by pausing recording. The
tone 4 recorded clip is divided.
times per • Recording resumes when
second the signal returns to normal.
Recording does not resume
if interval, one-shot or loop
recording is in progress.
Indicates poor reception
from the wireless receiver.
No Recording continues but
wireless microphone cannot
be received.
(Continued on the next page)
Countermeasures
Check the cause
indication * and
1
consult your
distributor.
Turn off the power.
Repair the P2 card if
the clips on the card
are corrupted.
Replace the battery.
Delete clips that are
no longer needed or
insert a new card.
Turn the power off
and then back on
again and check
recording and
playback. Replace
any P2 card that
does not enable
normal recording.
Check the
GENLOCK IN signal.
Check microphone
power supply and
receiver reception
status.
11