Recording Setup Screen - Panasonic HPX300 - Camcorder - 1080p Operating Instructions Manual

Item
AUTO KNEE SW Selects the function of the OUTPUT/AUTO KNEE.
ON: Setting AUTO KNEE to ON turns on the AUTO
KNEE function.
OFF: The AUTO KNEE function is not available even
when AUTO KNEE is set to ON.
DRS: Setting AUTO KNEE to ON turns on the DRS
(Dynamic Range Stretcher) function. (For details, refer
to page 9.)

RECORDING SETUP screen

Item
REC FUNCTION Sets special recording modes.
NORMAL: The special recording modes are not used.
INTERVAL: Sets interval recording.
ONE SHOT: Sets one-shot recording.
LOOP: Sets loop recording.
For details, refer to [Special Recording Modes]
(page 38).
• This function is always set to NORMAL when the
power is turned on.
ONE SHOT TIME Sets the time interval for one-shot recording.
1frm, 2frm, 4frm, 8frm, 16frm, 1s
For details, refer to [One shot recording (ONE SHOT
REC)] (page 39).
INTERVAL TIME Sets the time interval of interval recording.
2frm, 4frm, 8frm, 16frm, 1s, 2s, 5s, 10s, 30s, 1min,
5min, 10min
For details, refer to [Interval recording (INTERVAL
REC)] (page 39).
START DELAY This delays the start of interval and one-shot recording
by about 1 second.
ON, OFF
PREREC MODE Sets PRE REC.
ON, OFF
For details, refer to [Pre-recording (PRE REC)]
(page 38).
TC MODE Sets count correction when using the internal time
code generator.
DF: Drop frame time code
NDF: Non drop frame time code
For details, refer to [Setting the Time Code] (page 60).
UB MODE Sets the data recorded in the camera user bits.
USER, TIME, DATE, EXT, TCG, FRM.RATE
For details, refer to [Setting user bits] (page 58).
Setting
Setting
Notes
• In the following conditions, selecting
DRS results in the same operation
mode as when ON is selected.
- When set to 1080/30PN, 1080/24PN
mode.
- When set to 1080/60i mode with the
1/15, 1/30 shutter speed.
Notes
• Not available in the following
conditions.
- When REC SIGNAL is set to 1394
- When REC FORMAT is set to native
recording.
- When SYSTEM MODE is set to
1080-59.94i or 480-59.94i; and
CAMERA MODE is set to 24P or
24PA.
• Available only when REC FUNCTION
is set to ONE SHOT.
• Available only when REC FUNCTION
is set to INTERVAL.
• Available only when REC FUNCTION
is set to INTERVAL or ONE SHOT.
• Not available in the following
conditions.
- When REC SIGNAL is set to 1394
- When SYSTEM MODE is set to 720-
59.94P and VFR is set to ON.
- When REC FORMAT is set to native
recording.
- When SYSTEM MODE is set to 1080-
59.94i or 480-59.94i; and CAMERA
MODE is set to 24P or 24PA.
- When REC FUNCTION is set to
something other than NORMAL.
• Not available when operating at 24P,
24PA and 24PN. Then NDF is counted
at all times.
____ indicates the factory setting
1