Setup Menu List; Scene File Screen - Panasonic HPX300 - Camcorder - 1080p Operating Instructions Manual

Setup menu list

SCENE FILE screen

Item
LOAD/SAVE/INIT Loads, saves and initializes settings of the scene file
assigned to the current scene dial position (one F1
– F6 scene file).
LOAD: Loads data stored in camera memory.
SAVE: Saves current values in camera memory.
INITIAL: Returns settings to their factory defaults.
VFR Enables or disables variable frame rate (VFR) mode at
720P.
ON: VFR operation
OFF: VFR off
FRAME RATE Adjusts the frame rate and exposure time at 720P
when VFR is on.
12, 15, 18, 20, 21, 22, 24, 25, 26, 27, 28, 30, 32, 34,
36, 40, 44, 48, 54, 60 FRAME
(SYNCHRO SCAN) Displays synchro scan shutter speeds to enable the
operator to synchronize the camera to computer
monitors.
• This function only displays the shutter speeds. Use
• Set values (displayed values) are assigned to the
For details, refer to [Placing the Camera-recorder in
SYNCHRO SCAN Mode] (page 51).
1/60.0
DETAIL LEVEL Adjusts the level of image outline correction (in
horizontal and vertical directions).
–7 ... 0
V DETAIL LEVEL Adjusts the level of correction in vertical direction.
–7 ... 0
DETAIL CORING Adjusts the level of noise reduction of the detail signal.
–7 ... +5
• Adjust towards – for a clearer image. Noise
• Adjust towards + for less noise.
CHROMA LEVEL Adjusts the chroma level.
–7 ... 0
CHROMA PHASE Makes fine adjustments to the chroma phase.
–7 ... 0
COLOR TEMP Ach Makes fine adjustments to the color temperature (after
Ach white balance adjustment).
–7 ... 0
COLOR TEMP Bch Makes fine adjustments to the color temperature (after
Bch white balance adjustment).
–7 ... 0
*1 The factory default when the SCENE FILE dial is set to F1.
1
Setting
the SYNCHRO SCAN switch to set a shutter speed.
current scene file and manipulated using the LOAD,
SAVE and INIT functions.
*1 ... +7
... +7
*1
... +7
*1
increases slightly.
... +7
*1
... +7
*1
... +7
*1
... +7
*1
Notes
• A change in scene files affects only
the scene file at the current scene dial
position.
• Available only in 720P system mode.
(This message does not appear in
modes other than 720P.)
• This setting cannot be made when
REC SIGNAL is 1394.
• Available only in 720P system mode
and when VFR is set to ON.
(This message does not appear in
modes other than 720P.)
• This setting cannot be made when
REC SIGNAL is 1394.
• A change to 24 fps may cause the
screen to flicker momentarily.
• Displayed in blue when not set to
synchro scan mode and when the
SYNCHRO SCAN switch settings are
not available.
____ indicates the factory setting