Installing The Fan Blades; Installing The Ceiling Cover - Emerson CF710AB01 Owner's Manual

Builder plus series 42” model; 50” model

Hide thumbs

Table Of Contents

Table of Contents

Enlarged version

2. Securely connect the fan motor white wire to the

supply white (neutral) wire using wire connector

supplied (Figure 9). Securely connect the fan

motor black wire and blue wire to the supply black

(hot) wire using wire connector supplied (Figure 9).

After connections have been made, turn leads

upward and carefully push leads into the outlet

box, with the white and green leads on one side of

the outlet box and the black and blue leads on the

other side of the outlet box.

WIRE CONNECTOR

BLACK

SUPPLY (HOT)

BLUE

FAN WIRE

BLACK

FAN WIRE

WHITE SUPPLY

NEUTRAL)

WHITE FAN WIRE

Figure 9

Check to see that all connections are tight, including

ground, and that no bare wire is visible at the wire

connectors, except for the ground wire. Do not

operate fan until blades are in place. Noise and fan

damage could result.

Installing The

Ceiling Cover

1. Remove the left screw and lockwasher from each

side of the hanger bracket (Figure 10) and loosen

the other two screws.

NOTE: When installing the ceiling fan using the

close-to-the-ceiling method, carefully lift the fan

assembly from the hook on the hanger bracket

and proceed as follows.

2. Lift the ceiling cover up to the hanger bracket.

Engage the slots in the ceiling cover with the

loosened screws in the bracket and turn the cover

counterclockwise (Figure 10). Be sure that the

lockwashers are between the screw heads and the

ceiling cover.

3. Install the other two screws and lockwashers;

tighten all screws securely.

SUPPLY

GROUND WIRE

GREEN GROUND

WIRE FROM HANGER

BRACKET

GREEN GROUND

WIRE FROM HANGER

BALL

WARNING

INSTALL SCREW AND WASHER

LOOSEN THIS

SCREW

REMOVE THIS

SCREW AND

LOCKWASHER

Figure 10

To avoid possible fire or shock, make sure that the

electrical wires are completely inside the outlet box

and not pinched between the ceiling cover and the

ceiling.

4. Cut the speed control switch pull chain and the

light switch pull chain to the desired lengths.

Connect the wood pendants (supplied) to the pull

chains by sliding the pendants (small hole first)

onto the pull chains. Then attach the chain

couplings (supplied) to the end of the chains and

allow the pendants to fall down over the couplings.