Ccd Camera; Connecting Other Company's Image Equipment - Clarion VRX653R Owner's Manual & Installation Manual

CCD Camera

Monitoring the CCD camera
The CCD camera can be connected to this
unit. For the power supply of the camera,
mount the power box sold separately (CCA-
188).
Notes:
• This function is not available when the display is
stored.
• When the TV tuner and CCD camera are to be
connected to this unit, connect the CCD camera
to the CCD input terminal on this unit.
• Refer to the subsection "Sample System 3" in
"9. SAMPLE SYSTEMS" section.
Setting CCD as an external input
equipment
Be sure to perform this setting after connecting
the CCD.
∗ The factory default setting is "NAVI".
1. When the panel is open, press the ADJ
button * to show the adjustment selection
display.
2. Operate the JOYSTICK ¡ upward or
downward to select "INPUT". A menu bar is
shown to the right to select the following
items:
G "NAVI": Setting when Clarion NAVI is
connected;
G "CCD": Setting when Clarion CCD
camera is connected to this unit;
G "RGB": Setting when a RGB image of
other company's equipment is input;
G "COM": Setting when a composite image
of other company's equipment is input.
3. Operate the JOYSTICK ¡ rightward or
leftward to select "CCD". Press the ENT at
the center of the JOYSTICK ¡ to set
connection of the CCD.
38
VRX653R
Connecting other
company's image equipment
RGB type or composite type images from other
company's equipment can be displayed on this
unit
Be sure to perform this setting after connecting
the RGB type or composite type image
equipment to the RGB terminal.
∗ The factory default setting is "NAVI".
1. When the panel is open, press the ADJ
button * to show the adjustment selection
display.
2. Operate the JOYSTICK ¡ upward or
downward to select "INPUT". A menu bar is
shown to the right to select the following
items:
G "NAVI": Setting when Clarion NAVI is
connected;
G "CCD": Setting when Clarion CCD
camera is connected to this unit;
G "RGB": Setting when a RGB image of
other company's equipment is input;
G "COM": Setting when a composite image
of other company's equipment is input.
3. Operate the JOYSTICK ¡ rightward or
leftward to select "RGB" or "COM".
G To connect an RGB equipment:
If the image equipment to connect is RGB
type, select "RGB". Equipment capable to
be connected should have positive polarity
signal of 0.7 V p-p for RGB, and negative
polarity signal of 0.3 V p-p for synchronous
signal.
G To connect a composite type
equipment:
If the image equipment to connect is a
"Composite" type, select "COM".
∗ These settings cannot be selected when the
DVD changer is connected.
4. Then, press the ENT at the center of the
JOYSTICK ¡ to set the connection.
Display changeover
When the panel is open, it is possible to
change over between AV display and external
equipment display using the NVG/AV button
).