Hitachi 32LD7200 User Manual page 31

OPERATING INSTRUCTIONS (continued)
SETUP MENU (TV mode) (continued)
Selected characters
Auto Tuning
Country
Search
Manual Tuning
Position
Search
(C--)
(S--)
(--MHz)
Descrambler
Name
Sound System
Colour System
Skip
NR
Decreasing the frequency data
Fine Tuning
for the main tuner
Sort
(A Line of position List)
Teletext Language
Auto Off
30
− −
− −
− −
− −
− −
Off On
( :a letter)
Auto PAL SECAM
NTSC3.58 NTSC4.43
Off On
Off On
Increasing the frequency data for
the main tuner.
− −
− −
Off On
Setup hint
Select the country name by and
•
If some required stations could not be preset in this auto tuning function,
select and preset the required station in the required position by the
manual tuning operation.
Press the OK button and it starts the auto tuning.
Set the position number (1~199 and AV00) or channel number by ( + ) ( - )
CHANNEL UP/DOWN button.
At first, select the channel entry method, entering a two digit channel
number(CH), entering a two digit S-band number or entering a three digit
frequency(MHz), by pressing the OK button.
Enter two digit number by pressing 0~9 NUMBER buttons. If the number is
normal, then it starts the channel search.
Enter two digit number by pressing 0~9 NUMBER buttons. If the number is
normal, then it starts the channel search.
Enter three digit number by pressing 0~9 NUMBER buttons. If the number is
normal, then it starts the channel search.
Set this to Off normally. If it is set to On, AV1 (Scart) terminal operates as TV
signal output, and the screen changes to display AV1 (Scart) input signal
automatically.
This is used to input the name of the TV station within 5 letters. After fixing
the cursor on the first digit, select a letter by
move to next digit by ADJUST button. Press the OK button again after
finished.
•
Selectable letters are "0"~"9", "A"~"Z", "+", "-", " "(Blank),"," (comma) and
"."(Period).
Select the sound system through the 5 different settings.
Select the colour system through the 5 different settings.
If this is set to On, that position will be skipped whilst selecting positions by
CHANNEL UP/DOWN button.
This is automatically set to On for those non-broadcasting channels.
If this is set to On, it helps to reduce the noise interference visible on the
screen, especially in the weaker signal reception areas.
After completing the fine-tuning, press the RETURN button to exit this mode.
• The variable range is -56 ~ +56.
Press OK button at a line that is required to change order, then the
characters will change to green. And move it up or down in the list by
pressing and SELECT buttons. And press OK button to complete it.
Press the RETURN button to exit.
Select the Teletext Language, depending on the area utilized through the 4
settings: West Europe, East Europe, Cyrillic and Greek/Turkish.
If this is set to On, the power will be turned off when there is no transmission
signal and no operation for about 10 minutes in the TV mode.
SELECT buttons and press OK button.
and SELECT buttons and