Utility (0V Suspend) - EUROCOM 7200 User Manual

Utility
0V Suspend (HDPREPEZ.EXE)
The utility HDPREPEZ.EXE is used to create the 0V -Suspend partition or DOS FAT-
compatible file reserved for storing the system state during a 0 Volt suspend mode.
1. Insert the 0V-Suspend Utility in the appropriate drive, for example Drive A:,
to create a configuration file named HDPREP.CFG.
2. A screen will appear for configuration as shown in the next page.
3.
DosFile=1
4.
SelectedLogicalDrive=C
5.
SystemMemory=AUTO
6.
VGAMemory=AUTO
7.
AdditionalMemory=0
8.
Program1=ZVSR.PMD
9. Program2=LOGO.PMD
10.
Create file HDPREP.CFG (Y/N)? Options: Y for Yes, or N for No.
(Keep the diskette write-enable and press Enter to create HDPREP.CFG on it.)
11.
Execute the HDPREPEZ.EXE utility again to create the DOS FAT -compatible file or
create the partition.
A:\>HDPREPEZ
12. Reboot your Notebook system.
A:\>HDPREPEZ /C
Options: 1 = Save to DOS file.
0 = Partition (Use your operating system's
FDISK program to create a partition on the
hard disk whose size should accommodate
the following configured memory.)
Options: Select logical drive from C to Z if
Save to DOS file.
Options: Enter system memory in KB, e.g. 8096,
or AUTO for auto-detection.
Options: Enter video memory in KB, e.g. 1024,
or AUTO for auto-detection.
Options: Enter additional memory to reserve in
KB, or 0 if none.
Options: Use ZVSR.PMD default display file,
or enter Path \FileName for 0V
Suspend/Resume display program,
or _None_ for no display program.
Options: Use LOGO.PMD default display file,
or enter Path \FileName for logo display
program,
or _None_ for no display program.
59