Disassembly And Assembly; Housing Removal - Epson ActionLaser 1300 EPL-3000 Service Manual

Disassemble and Assembhf

3.2 DISASSEMBLY AND ASSEMBLY

This section describes and illustrates the procedures !br removing and disassembling the
components of the EPL-3000 and ActionLaser 1300. Cleaning is described in Chapter 6. The
assembly procedures are not described, except fir special notes where necessary, because assembly
can be accomplished by performing disassembly in reverse.

3.2.1 Housing Removal

This section describes how to remove the cases and the rear frame.
3.2.1.1 Caae Removal
Open the top cover. Remove the imaging cartridge. Cover the imaging cartridge to protect it
1.
from the light or place it in a dark area.
2.
Remove the CC screw (M3 x 8) and panel cover.
Remove the paper tray.
3.
4.
Remove 2 CC screws (M3 x 8) and the front cover.
Remove interfa~ cover.
5.
6.
Remove 2 CC screws (h43 x 8) and right cover.
7.
Remove 2 CC screws (M3 x 8) and left cover.
Remove the top cover.
8.
\
Left Cover
Front Cover
Figure 3-1. Removing the Housing
Interface Cover
/ CC(M3X8)
Tray
Rev. A