Overview; Precautions For Disassembling The Printer - Epson Stylus 820 Service Manual

Stylus Color IIs / Stylus 820

3.1 OVERVIEW

This section describes procedures for disassembling the main components of the printer. Unless otherwise
specified, disassembled units or components can be reassembled by reversing the disassembly procedure.
Therefore, no assembly procedures are included. Precautions for any disassembly or assembly procedure are
described under the heading "Disassembly/Assembly Points." Adjustments required after assembling the unit
are described under the heading "Required Adjustments."

3.1.1 Precautions for Disassembling the Printer

See the precautions below when disassembling the printer.
oDisconnect the power cable before disassembling or assembling the printer.
oWear goggles to protect your eyes from ink. If ink gets in your eye, flush it with fresh water
and see a doctor immediately.
oIf ink comes into contact with your skin, wash it off with soap and water. If irritation
occurs, contact a physician.
oUse only O9 oil when lubricating the carriage guide shaft.
oNever remove the ink cartridge from the carriage unless manual instructions specify to
do so.
oWhen transporting the printer after installing the ink cartridge, be sure to pack the
printer for transportation without removing the ink cartridge.
oUse only recommended tools for disassembling, assembling, or adjusting the printer.
oApply lubricants and adhesives as specified. (See Chapter 6.)
oMake specified adjustments when you disassemble the printer. (See Chapter 4.)
3.2 DISASSEMBLY AND ASSEMBLY
This section consists of the subheads shown in the diagram below. See the exploded view of the printer in the
Appendix, if necessary.
Follow the precautions in Section 3.1.1 when disassembling the printer.
This section consists of the subheads shown in the diagram(next page).
Rev. A
WARNING
CAUSION 1
CAUTION 2
WARNING
Disassembly and Assembly
3-1