Adjustments
4.1.1 Destination Data Writing Operation
The setup value that specifies the printer destination (for character generation and panel default settings) is
stored in the EEPROM on the C160 MAIN Board. Therefore, this setup value must be written into the
EEPROM when the main board or EEPROM chip is replaced.
Before writing the destination data writing, set the interface to parallel.
1.
Connect the PC to the target printer using a parallel interface cable and turn the printer on.
2.
Execute BASIC on the PC, and run the program HUDSON.BAS. You see the following menu:
Stylus / MJ Program H90E00E
***** Model *****
1. Stylus Color IIs
2. Stylus 820
3. MJ-500C
7. END
3.
When the main menu appears, choose the product name by typing 1 or 2 and E n t e r .
4.
You see the following menu.
Stylus / MJ Program H90E00E
***** Customer *****
1. EAI, EAI (Latin America), EAL, ESP, ETT
2. EUL, EDG, EFS, EIS, EIB, EUL (North Europe), EUL (Middle East), EHK
3. [EDG (NLSP)]
4. Russia
Slect Menu ?
5.
Select your country.
6.
If you have completed all your selections, turn off the printer.
Note:
It is not necessary to turn off the printer if you want to perform the other adjustments.
4-2
CAUTION
Stylus Color IIs / Stylus 820
Rev. A