Epson LQ-1050 Technical Manual page 36

REV.-A
LOAD/EJECT Switch
Pressing this switch loads or ejects the paper (If a page is inserted into the cut sheet feeder, it is loaded;
if a page is already loaded, it is ejected). Details of the paper loading and ejection process are described
in Section 1.9.1.1.
FONT Switch
Pressing this switch selects a font, and continuing
the next font, sequentially. The FONT indicator lights beside the currently selected font.
PITCH Switch
Pressing this switch selects the character pitch, and continuing to press the switch for more than 0.5
seconds select the next character pitch, sequentially. The PITCH indicator lights beside the currently
selected character pitch to confirm its status.
CONDENSED Switch
Pressing this switch selects normal or condensed printing. The CONDENSED indicator lights while
selecting the condensed mode.
POWER LED (Green)
Lights when power is ON.
READY LED (Green)
Lights when printer can receive the data.
PAPER OUT LED (Red)
Lights when the paper is end,
ON-LINE LED (Green)
Lights in the ON-LINE mode.
MULTI-PART LED (Orange)
Lights when the head adjustment lever is set for 4th or higher. The light should not be lit unless multi-part
forms are being printed.
FONT (DRAFT, ROMAN, SANS-SERIF, SLOT A, SLOT B) LEDs (Orange)
These LEDs indicate the currently selected font. If slots A and B contain font modules, they each may
be selected using the FONT switch, and the indicator beside either SLOT A or SLOT B will be lit. If no
font module is installed in the slot when the FONT switch is pressed, SLOT A and SLOT B selections
will be skipped.
PITCH (1 O CPI, 12 CPI, 15 CPL PROPORTIONAL) LEDs (Orange)
These LEDs indicate the currently selected character pitch.
NOTE: When 15 CPI is selected, condensed printing may not be used,
CONDENSED LED (Orange)
This indicator lights when condensed mode printing is selected.
to press the switch for more than 0.5 seconds select
1-28