DURKOPP ADLER 768 Setting Instructions Manual page 23

6.10.2.2 Setting Positions with the V810 Control Panel
Entry of the code number for the technician level
–
Turn the main switch off.
–
All plugs on the controls of the sewing drive must be plugged in.
–
Press the "P" key and hold pressed.
–
Turn the main switch on. The display shows "C-0000"
–
Release the "P" key
–
Enter code no. 1907. With the "+" and "-" keys, the value of the blinking number is
changed. The next number is called up with the ">>>>" key.
–
Press the "E" key. The first parameter, F-100, at the technician level is shown.
Setting the reference position
–
After entry of the code number press the "E" key.
The first parameter, F-100, at the technician level is shown.
–
With the "+", "-" and ">>>>" keys set the parameter F-170.
–
Press the "E" key. Shown in the display = "Sr1"
–
Press the ">>" key. Shown in the display = "PoS0 ( )"
–
Turn the handwheel in the normal direction of turn until the character "( )"
disappears from the display, then turn farther until the reference position (needle
point, with lowered needle, at the level of the top of the needle plate) is reached.
–
Press the "E" key. The reference position is saved. Shown in the display "F- 171"
–
If the reference position was not saved, an error message appears in the display =
"inF E3". Turn the handwheel farther, press the "E" key and repeat the procedure
above.
Setting positions 1 and 2
–
The reference position is set. (see above)
–
Enter parameter F-171.
–
Press the "E" key. Shown in the display = "Sr2"
–
Press the ">>" key. Shown in the display = "1 xxx" = parameter value of pos. 1.
–
If necessary, correct parameter value *. Either with the "+" and "-" keys or by
turning the handwheel.
–
Press the "E" key. Shown in the display = "2 xxx" = parameter value of pos. 2
–
If necessary, correct parameter value *. Either with the "+" and "-" keys or by
turning the handwheel.
–
Press the "E" key. Shown in the display = "1A xxx" = parameter value of pos. 1A
–
If necessary, correct parameter value *. Either with the "+" and "-" keys or by
turning the handwheel.
–
Press the "E" key. Shown in the display = "2A xxx" = parameter value of pos. 2A
–
If necessary, correct parameter value *. Either with the "+" and "-" keys or by
turning the handwheel.
–
Press the "P" key twice. The settings are completed, the programming level is
exited
–
Check the positions. See Chapter 6.10.2.4
* Attention! The parameter values for the positions 1, 2, 1A and 2A are to be found on
the parameter sheet (accessories pack).
GB
23