DURKOPP ADLER 768 Setting Instructions Manual page 26

6.11.3 Table of the Machine-specific Parameters of the DA82GA Controls
The values of the parameters listed in the following must be changed from the preset
value.
The values (x) to be set are to be found in the parameter sheet 9800 130014 PB51
(In the accessories pack of the machine).
Parameters
F-111
F-117
F-147
F-171
F-196
F-197
F-225
* T = Parameters at the technician level, A = Parameters at the supplier level
26
* Designation
T Upper limit of the maximum speed
T High lift walking speed
T Functions of the pushbutton on D.3
T Position 2
Position 2A
T Function of both thread tension release
with presser foot lifting
T Function of 2.thread tension with
HP and Speedomat
A Speed regulation,
0 = machine normal, 1 = machine middle heavy
NOTE !
The altering of the parameter values must be conducted
very carefully because the machine can be damaged
through incorrectly set drive controls! All parameter values
can be reset to the delivery status (preset values) by a
master reset. See Chapter 6.12
768
x
x
x
x
x
x
x
x