Mounting The Synchronizer; Connecting The Sewing Machine Head - DURKOPP ADLER 768 Setting Instructions Manual

1
6.7

Mounting the Synchronizer

–
Place the synchronizer 3 on the handwheel flange.
The groove 6 on the housing of the synchronizer must lock over the twist barrier 5
on the belt guard.
–
Tighten both set screws 2 on the synchronizer ring 4.
–
Guide lead 7 of the synchronizer down through the cutout in the table top
–
Faire passer le câble de raccordement du transmetteur de position latéralement
dans la conduite de câbles sous la tablette et le poser vers l'avant.
–
Insert the plug of the synchronizer into the socket b1 of the drive controls.
(See section 6.6)
6.8

Connecting the Sewing Machine Head

The electrical connection to the sewing machine head occurs via the central plug
connection 1.
–
Insert the plug (16-pin) of the connection lead into the socket of the sewing
machine head.
–
Guide the connection lead down through the cutout in the table top.
–
Insert the plug (37-pin) into the socket A of the drive controls.
(See section 6.6)
20
4 5
2
3
6 7