DURKOPP ADLER 768 Setting Instructions Manual page 27

6.11.4 Setting Parameter Values with the Control Panel V810
Changing parameter values at the "Technician Level"
Entry of the code number for the technician level
–
Turn the main switch off.
–
All plugs on the controls of the sewing drive must be plugged in.
–
Press the "P" key and hold pressed.
–
Turn the main switch on. The display shows "C-0000"
–
Release the "P" key
–
Enter code no. 1907. With the "+" and "-" keys the value of the blinking number is changed.
The next number is called up with the ">>" key.
–
Press the "E" key. The first parameter, F-100, at the technician level is shown.
Selecting the parameters and changing the values
–
The next or the previous parameter is selected with the "+"and "-" keys.
–
The parameter can be entered directly with the ">>", "+",and "-" keys.
–
Press the "E" key. The value of the selected parameter is shown.
–
The parameter value can be altered with the "+" and "-" keys.
–
Press the "E" key. The next parameter is shown.
or press the "P" key - the same parameter is shown.
Saving changed parameter values
–
Press the "P" key, programming is ended.
–
Sew a complete seam, that is, step the pedal forward and then completely back.
The change is saved.
–
If no seam is sewn, the change is lost.
–
Through renewed pressing of the "P" key one returns to the programming level.
Changing parameter values at the "Supplier Level"
Entry of the code number for the supplier level
–
Turn the main switch off.
–
All plugs on the controls of the sewing drive must be plugged in.
–
Press the "P" key and hold pressed.
–
Turn the main switch on. The display shows "C-0000"
–
Release the "P" key
–
Enter code no. 3112. With the "+" and "-" keys the value of the blinking number is
changed. The next number is called up with the ">>" key.
–
Press the "E" key. The first parameter, F-200, at the supplier level is shown.
–
Proceed as in "Selecting the Parameters and Changing the Values"
NOTE !
The altered parameter values are only then saved, when,
after exiting the programming level, a complete seam is
sewn, that is, step the pedal forward and then completely
back. If, after exiting the programming level, the drive is
immediately turned off the changes are lost.
GB
27