25. Gimp pulling device for subclasses 580-141000 and 580-341000
2
1
Caution: Danger of injury!
Adjust the gimp pulling device only in position "Safe stop" or with the
machine switched off respectively.
Standard checking
The drop weight 2 pulls the gimp back to the correct initial length.
The course of the drop weight has to be limited by the stop screw 3 in
such a way that the gimp is as short as possible at the sewing start, but
sewn in safely.
This is the case when the gimp end juts out of the gimp hole of the
throat plate by approx. 4 mm.
Correction
–
Screw in screw 3 = longer gimp end
–
Screw out screw 3 = shorter gimp
3
3
77