Locking Of The Clamping Plates - Duerkopp Adler 580 Service Instructions Manual

8.6

Locking of the clamping plates

2 1
Caution: Danger of injury!
Exercise utmost caution when making adjustments with
the machine running.
Standard checking
There must be a minimum clearance in the height of the inserted
clamping plates 2 when:
·
no material is loaded.
·
approx. 8 mm thick material is loaded and the clamps are closed.
–
Insert the clamping plates.
–
Switch the machine on.
–
Close the fabric clamps.
–
Check at the fabric clamp fixture 1 whether the clamping plate can
be minimally lifted.
–
Load 8 mm thick material.
–
Check at the fabric clamp fixture 1 whether the clamping plate can
be minimally lifted.
Correction
–
Switch the machine off.
–
Remove the clamping plates.
–
Loosen the threaded pin 3.
–
Adjust the stop 4.
–
Tighten the screws 3.
4 3
3
27