Controls And Control Panel; General - DURKOPP ADLER 381 Operating Instructions Manual

7. Controls and Control Panel

7.1 General

The controls are programmed and the functions for the seams are set via the control
panel.
Appropriate to the sewing task, sewing can occur manually or with seam programming.
For different sewing tasks the seam procedures can be programmed and their functions
(beginning bartack, end bartack, stitch counting, thread trimming, etc.) and parameter
values (number of stitches, seam length, speed, etc.) individually assigned.
The entry occurs in the programming mode.
The parameters and their assigned values are shown in the display.
The programmed seams remain in memory even after the sewing machine is turned off.
In order to avoid an unintentional changing of preset functions, operations are divided
among different levels ( operator, technician, equipper ).
The operator (seamstress) can program directly.
The access to the other levels is only possible after the entry of a code number or
different keys must be pressed simultaniously.
RESET
If the controls have been totally misadjusted, then the technician can return all setting
values to the delivery status (works setting) with this function.
The function is described in the Service Instructions for the 381 - 382 !
ATTENTION !
These Operating Instructions list only those functions of
the keys and the changes of the parameters to be
conducted by the operator.
Please find the comprehensive description of the controls
in the enclosed current Operating Instructions of the motor
manufacturer.
23