6.6 Inserting the Underthread Bobbin
1
Removing the empty underthread bobbin
–
Bring the needle bars into the high position.
–
Open the needle plate slides 1 and 2.
Unlock the right needle plate slide 2 by pressing down on the leaf spring 3.
–
Lift the bobbin case flap.
–
Remove the bobbin case with empty underthread bobbin.
Threading the underthread
–
Insert a full bobbin 4 into bobbin case 7:
When the thread is being drawn off, the bobbin must turn in the direction of the arrow.
–
Pull the underthread through slit 5 under tension spring 6.
–
Thread the underthread through hole 8 in the bobbin case top.
This assures the thread trimming function.
–
Cut off the underthread up to approx. 3 cm.
–
Insert the bobbin case top with full bobbin into the hook.
–
Close the bobbin case flap.
–
Close the needle plate slides 1 and 2 again.
14
2
3
Caution Risk of Injury !
Turn the main switch off.
Change the underthread bobbins only with the sewing
machine turned off.
4
5
6
7
8