6.12.1 Stitch Length on Sewing Machines with Automatic Bartacking
1
2
3
Sewing machines with automatic bartacking
( Subclass 381-160162 and 382-160162 )
On sewing machines with automatic bartacking the stitch lengths are set with the
knurled nut 3 and the block 1.
The knurled nut in the stitch regulator lever (see pos. 1 page 19) is turned completely
back.
–
Tilt the sewing machine head back.
–
Turn the knurled nut in the stitch regulator (see pos. 1 page 19) completely back.
–
Set the stitch length for reverse sewing.
Loosen screw 2.
Decrease stitch length = Push block 1 up.
Increase stitch length = Push block 1 down.
Tighten screw 2 again.
ATTENTION !
–
Set the stitch length for forward sewing.
Decrease stitch length = Turn knurled nut 3 clockwise.
Increase stitch length = Turn knurled nut 3 counterclockwise.
–
Right the sewing machine head again.
20
Caution Risk of Injury !
Turn the main switch off.
Set the stitch length only with the sewing machine turned off.
With the moving of block 1, the stitch length for forward sewing
changes.