Changing The Parameter Values - DURKOPP ADLER 381 Operating Instructions Manual

7.3 Changing Parameter Values
The changing of parameter values at the operator level occurs via the four green keys
("P", "E", "+", "-") under the display.
In the parameter list on the next page are listed all parameters which can be changed at
the operator level.
1. Accessing the programming mode
-
Press the "P" key.
The LED above the key blinks.
It shows that the controls are in the programming mode.
2. Displaying the first parameter of the operator level
-
Press the "E" key.
The first parameter with the corresponding parameter value appears in the
display.
Example: "Arv 003"
3. Changing the parameter value shown
-
Increase or decrease the parameter value with the "+" and "-" keys.
If the "+" or "-" key remains pressed the parameter value continues changing until
the key is released.
4. Storing the changed parameter value
-
Press the "E" key.
The changed parameter value is stored.
-
The next parameter of the operator level appears in the display.
Through repeated pressing of the "E" key, all parameters of the operator level are
called up sequentially.
5. Exiting the programming mode
-
Press the "P" key.
The parameter value changed last is stored.
-
The controls exit the programming mode.
Arv = Short designation of the parameter
003 = Set parameter value
25