DURKOPP ADLER 381 Operating Instructions Manual page 27

Sewing procedure
In the seam middle
Interrupting the sewing
procedure
Continuing the sewing
procedure
(after release of the pedal)
Sewing a corner
Sewing an intermediate bartack
At the seam end
Removing the material
End bartack is not to be sewn
Operation / Remarks
- Release the pedal (rest position) .
The machine stops in the first position
(needle down).
The sewing feet are down.
- Step forward on the pedal.
The machine sews at the speed determined
with the pedal.
The beginning bartack is not sewn.
- Release the pedal.
The machine stops in the first position
(needle down).
The sewing feet are down.
- Turn the needle bar right or left off.
- Conduct the required stitches with the second
needle bar.
- Step half back on the pedal
- Turn the material around the needle.
Only one needle may be in the material.
- The sewing feet lower.
Sew the necessary stitchs.
- Turn the needle bar on again.
- Press key 2 and hold the pedal down.
The machine sews in reverse as long as key 2
is pressed.
The speed is determined by the pedal.
- Step the pedal completely back and hold down.
The end bartack is sewn.
The thread is trimmed.
The machine stops in the second position.
The sewing feet are raised.
- Press key 3 (bartack suppression).
Step the pedal completely back.
The end bartack is not sewn.
The thread is trimmed.
The machine stops in the second position.
The position of the sewing feet is
dependent on press key 6 on the control panel:
a) ON:
- Sewing feet raised.
b) OFF:
- Sewing feet down.
29