Table of Contents
Advertisement
4. Operation Method
a. Preparation
1) Switch OFF the printer.
2) Connect the tester connector 1 to the envelope feeder connector (J24) in the printer.
3) Turn ON the printer.
4) When the printer is in standby mode, start performing checks with the tester.
Note:
When operating the printer driver tester, electrostatic energy can cause operation fail-
ures. Therefore, when connecting the tester be sure to touch a metal part of the print-
er with your hand to discharge any electrostatic energy.
Clip
Connector 1
Figure 4-8-4
CHAPTER 4
Connector 2
4 - 43
Advertisement
Table of Contents
Troubleshooting
