Installing The Optional Anamorphic Lens Mount; Installing The Movable Anamorphic Lens Transport Assembly - Runco LightStyle LS-1 series Operation Manual

If you are installing a standard LS-1 (without an anamorphic lens), skip this step and
proceed with Mounting the LS-1 (page 27).
If you are installing an LS-1 with a fixed anamorphic lens, proceed with
Installing the Fixed Anamorphic Lens Base Plate (page 26).
If you are installing an LS-1 with a movable anamorphic lens, proceed as
follows to install the lens mount and transport assembly.
1. Do not install the anamorphic lens yet, only the transport
Note
2. Some components shipped with your projector may differ slightly
Package Contents: The LS-1 movable anamorphic lens mount kit consists of the
following items. Some components shipped with your projector may differ slightly from
what is shown in these instructions. If any items are missing or damaged, please contact
your Runco dealer or Runco Customer Service at (800) 23RUNCO.
• Transport Assembly Attachment Plate
• Attachment plate hardware (screws,
washers and spacers)
• Attachment plate security hooks and
related hardware (chain, chain ends,
nuts and washers)
• Transport Assembly
• Transport mounting hardware
• Lens bracket mounting hardware
• Power supply
• Remote control unit and batteries
Runco LS-1 Installation/Operation Manual
assembly and/or lens mount. You will install the anamorphic lens
after you install the projector and adjust the primary lens.
from what is shown in these instructions.
21
Installation
3.4
Installing the Optional
Anamorphic Lens
Mount
Installing the Movable
Anamorphic Lens
Transport Assembly