Using Picture-In-Picture (Pip) - Runco LightStyle LS-1 series Operation Manual

Operation
4.4
Using
Picture-In-Picture (PIP)
For PIP purposes, there are three groups of inputs
separated by their display modes:
• Video (SD) group: Video, S-Video and SCART
inputs.
• Graphic (HD) group: Component 1, Component 2 and RGB inputs.
• Digital Video group: HDMI 1 and HDMI 2 inputs.
PIP shows one input from any of these groups within or beside one input from either of the
other two groups.
• Press PIP to enable the PIP function. Once enabled, press PIP repeatedly to select the
desired PIP source or turn PIP off.
• Press SWAP to swap the main and PIP images.
For more information, refer to PIP Position on page 65.
For each source, Table 4-1 shows which of the other sources are available as a PIP
source.
Table 4-1. Available Main and PIP Source Combinations
VIDEO
–
–
–
√
√
√
√
Notes:
√
1. " " means that that source is available as a PIP source with a given main source; "–" means that
it is not.
2. Disabled sources (refer to Source Enable on page 64) are not available as PIP sources.
PIP Input Source
S-VIDEO SCART COMP 1
– –
– –
– –
√ √
√ √
√ √
√ √
46
PIP SWAP
RGB HDMI 2
√ √ √
√ √ √
√ √ √
√
– –
√
– –
√ √
–
√ √
–
Runco LS-1 Installation/Operation Manual
LIGHT
HDMI 1
√
√
√
√
√
–
–