Table 3-1 gives a quick overview of the LS-1 installation process. The sections following
this one provide detailed instructions.
Installation should be performed by a qualified custom video
Note
installation specialist.
Table 3-1. Installation Overview
Step
Choose a location for the projector
1
Install anamorphic lens mounting assembly (optional)
2
3
Mount the projector
Connect signal sources to the LS-1
4
Connect external controller to RS-232 port and/or IR repeater
5
system (optional)
Connect 12-volt trigger output to retractable screen or other,
6
+12V trigger-activated equipment (optional)
Apply power to the projector
7
Primary lens adjustments: projected image size (zoom), position
8
(shift) and focus
Change the OSD Language (optional)
9
For rear-screen and/or ceiling-mount installations, select the
10
proper picture orientation
Install and adjust secondary anamorphic lens (optional)
11
Projector calibration: adjust the following for each input; save
settings when finished:
• Aspect ratio
• Brightness
12
• Contrast
• Color level
• Tint
• Input position
Runco LS-1 Installation/Operation Manual
Procedure
For Details, Refer
to page...
16
21
27
30
35
36
37
19, 38
39
39
40
48
15
Installation
3.2
Quick Setup