Table of Contents
Advertisement
18
Optional Grill Accessories
These grill accessories are optional and may be ordered directly from Cal Flame customer service. See page 21
for ordering information.
Sear Zone Infrared Burner
BBQ07890P
Pizza Brick Tray
BBQ07900
Smoke Tray
BBQ08854P
www.calflamebbq.com
The Sear Zone infrared burner can be use in place of any regular burner.
Producing intense infrared heat, it cooks quickly with searing heat to seal
in juices. (Note: The Sear Zone infrared burner is NOT the same as the
infrared back burner used with the rotisserie.)
Instructions for installing the optional Sear Zone burner are on page 32.
You can use your grill as a pizza oven using the pizza brick tray. Made of
stone and stainless steel, it fits on any Cal Flame grill and is large enough
to cook a large sized pizza.
Set the tray on the grates, set the burners to medium heat, and heat up
your grill for about 10 minutes. Place the pizza on the tray and close the
hood. Depending on the size of the pizza, it will need between 10 to 20
minutes to cook.
Any burner can be switched to accommodate the Smoke Tray.
1.
Remove a grate and a flame tamer (the angular metal piece covering
the burner). Do not remove the burner.
2.
Set the smoke tray in the grilling area so that the notches in the end
rest on the round metal posts attached to the inside of the grill area.
The smoke tray will resting over, but not ON, the burners.
3.
Place wood chips or charcoal in the Smoke Tray.
4.
Replace the grate.
5.
Ignite the burner under the Smoke Tray and turn it up to HIGH.
6.
Let it burn until the wood chips start to smoke. This should take 7 to
10 minutes. Then lower the heat to low.
Barbecue Grills
LTR50001038, Rev. C
Advertisement
Table of Contents
