DAVIS 6370 Installation Manual page 9

Wireless Temp Page 9 Thursday, December 7, 2000 2:09 PM
3. Using an adjustable wrench or 7/16" wrench, tighten the nuts.
4. Place the second U-bolt around the pole and through the two holes at the bottom of
the shelter.
Put a flat washer, a lock washer, and a hex nut on each bolt end, and tighten
the hex nuts.
Mounting on a Vertical Surface
1. With a 3/16" (5 mm) drill bit, drill two holes approximately 2" (50 mm) apart. Use a
carpenter's level to ensure the holes will be level.
2. Drill two more holes 7-1/32" below the upper holes.
M
OUNTING
3. Insert the 1/4" x 1-1/2" lag screws through the flat washers, and through the holes at
the top of the shelter into the post.
Using an adjustable wrench or 7/16" wrench, tighten the lag screws.
4. Insert the 1/4" x 1-1/2" lag screws through the flat washers, and through the holes at
the bottom of the shelter into the post.
Using an adjustable wrench or 7/16" wrench, tighten the lag screws.
Mounting the Wireless Temperature Station
T S V
EMPERATURE TATION ON A ERTICAL
Lag
Screw
Flat
Washer
S
URFACE
Page 9