Attaching Wheels; Attaching Handle; Installing Tow Bar - Burley Tail Wagon Owner's Instruction And Safety Manual

Attaching Wheels

1. Insert wheel axle assembly completely into trailer
axle.
FIGURE 3
2. Close quick release lever, with lever aimed at trailer rear.
A properly adjusted quick release lever should leave an
imprint on your palm when the lever is rotated to the closed
position.
FIGURE 4
3. Verify that tires are inflated to pressure marked on tire
side wall.
4. To remove wheel from trailer axle, open quick release lever.
WARNING
MAKE SURE WHEELS ARE HELD SECURELY, WITH WHEEL AXLE
ASSEMBLY FULLY INSERTED INTO TRAILER AXLE. YOU SHOULD
NOT BE ABLE TO ROCK OR SHIFT WHEELS. IMPROPERLY IN-
STALLED WHEELS CAN FALL OFF, CAUSING AN ACCIDENT OR
SERIOUS INJURY.

Attaching Handle

1. On handle ends, push button detents in and slide handle
into handle receivers by wheel axles, with handle extending
out over trailer rear (narrow end).
2. To remove handle, push buttons on front of handle
receivers and pull up on handle.

Installing Tow Bar

1. Slide tow bar through both tow bar mounts on left side.
2. Match rear tow bar hole with rear mount hole.
3. Insert the retaining pin through both holes, and lock
retaining hoop securely.
WARNING
NEVER OPERATE TRAILER WITHOUT RETAINING PIN LOCKED IN
PLACE. AN UNLOCKED TOW BAR CAN LOOSEN OR DETACH,
CAUSING ACCIDENT RESULTING IN SERIOUS INJURY.
PHOTO 3
PHOTO 4
Top View
FIGURE 3:
Quick release lever in unlocked
"open" position
Handle
Receiver
Button
Detent
PHOTO 3
Front
Tow Bar
Mount
PHOTO 4
B U R L E Y T A I L W A G O N O W N E R ' S I N S T R U C T I O N A N D S A F E T Y M A N U A L
Trailer
Rear
Top View
FIGURE 4:
Quick release lever in locked
"closed" position
Wheel
Axle
Rear Tow
Bar Mount Retaining Hoop
5