Hard Drive Guidelines - HP DL585 - ProLiant - G2 User Manual

DIMMs must be installed in decreasing capacity with the largest DIMMs installed in the banks
furthest from each processor.
NOTE:
populated, the maximum memory clock speed is 533 MHz. If two or fewer banks on a
memory node are populated, the maximum memory clock speed is 667 MHz.
To install a DIMM:
Power down the server (on page 27).
1.
Remove the processor memory module, and open the cover
2.
module" on page 32).
Open the DIMM slot latches.
3.
Install the DIMM.
4.

Hard drive guidelines

If all four banks on a memory node ("DIMM slot identification" on page 9) are
("Removing the processor memory
Hardware options installation 41