Hot-Plug Hard Drive Guidelines - HP ProLiant SL250s Gen8 User Manual

Install the DIMM.
6.
Install the processor air baffle.
7.
If removed, install the FBWC capacitor pack.
8.
Install the server into the chassis
9.
Power up the server (on page 14).
10.
If you are installing DIMMs in online spare, mirrored, or lock-step configuration, configure this mode in RBSU
("HP ROM-Based Setup
For more information about LEDs and troubleshooting failed DIMMs, see "Systems Insight Display LED
combinations."

Hot-plug hard drive guidelines

When adding hard drives to the server, observe the following general guidelines:
•
The system automatically sets all device numbers.
•
If only one hard drive is used, install it in the bay with the lowest device number.
•
Drives should be the same capacity to provide the greatest storage space efficiency when drives are
grouped together into the same drive array.
("Installing the server into the
Utility" on page 67).
chassis" on page 20).
Hardware options installation 34