HP DL585 - ProLiant - G2 User Manual page 45

CAUTION: If only one power supply is installed, do not remove the power supply unless the
server has been powered down. Removing the only operational power supply will cause an
immediate power loss.
NOTE: If you remove or replace the primary hot-plug power supply, use the T-15 Torx
screwdriver provided with the server to remove the shipping screw. It is located just under the
port-colored plastic handle of the power supply unit.
Remove the power supply blank.
1.
Install the power supply, and lock the lever.
2.
Connect the power cord to the power supply.
3.
Secure the power cords to the retaining clip.
4.
Connect the power cord to the power source.
5.
Be sure that the power supply LED is green.
6.
Be sure that the front panel external health LED is green.
7.
Hardware options installation 45