Operations; Power Up The Server; Power Down The Server; Extending The Server From The Rack - HP DL585 - ProLiant - G2 User Manual

Operations

Power up the server

To power up the server, press the Power On/Standby button.

Power down the server

WARNING:
remove the power cord to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the power supply and some
internal circuitry remain active until AC power is removed.
IMPORTANT:
Shut down the OS as directed by the OS documentation.
1.
Press the Power On/Standby button to place the server in standby mode. When the server enters
2.
standby power mode, the system power LED changes to amber.
Disconnect the power cords.
3.
The system is now without power.

Extending the server from the rack

The design of the server enables you to access several components through the front of the server.
Installing or accessing the following components will not require extending the server from the rack:
Processors
PPMs
Processor memory board
DIMMs
DVD drive
Optional diskette or CD-ROM drive
Hard drives
To extend the server from the rack:
Pull down the quick-release levers on each side of the server to release the server from the rack.
1.
Extend the server on the rack rails until the server rail-release latches engage.
2.
To reduce the risk of personal injury, electric shock, or damage to the equipment,
If installing a hot-plug device, it is not necessary to power down the server.
Operations 27