Brother MFC-9420CN User Manual page 171

Chapter D
Putting paper in the lower tray unit
After you have installed the lower paper tray,
you can put paper in it the same way you put
paper in the upper paper tray.
Improper Setup
Do not put transparencies, labels or
envelopes in the paper tray of the optional
lower tray unit. This might cause paper
jams.
SO-DIMM (Memory)
The memory board is installed on the main
controller board inside the machine. When
you add the optional memory board, it
increases the performance for both copy and
print operations.
The machine has 64 MB of standard memory
and a slot for optional additional memory. The
memory can be expanded up to a total of 576
MB by installing a commercially available
SO-DIMM (Dual In-line Memory Module).
The machine uses memory modules that are:
144 pins, no-parity, SDRAM with 64 MB or
more.
The machine is not compatible with Extended
Data Output (EDO) DIMM.
D - 3
The following SO-DIMM sizes can be
installed:
■
64 MB TechWorks
■
128 MB TechWorks
■
256 MB TechWorks
■
512 MB TechWorks
Note
For more information, visit TechWorks web
site at www.techworks.com
In general, SO-DIMM must have the following
specifications:
Type: 144 pin and 64 bit output
CAS latency: 2 or 3
Clock frequency: 100 MHz or more
Capacity: 64 MB to 512 MB
DRAM type: SDRAM
■
The machine's standard memory can vary
depending on the machine model and the
country.
■
There might be some SO-DIMMs that will
not work with this machine.
■
For more information, call the dealer you
bought the machine from or Brother
Customer Service.
■
For the latest information, visit the Brother
Solutions Center at
http://solutions.brother.com
12345-0001
12462-0001
12485-0001
12475-0001