Federal Communications Commission (Fcc) Declaration Of Conformity (Usa Only) - Brother MFC-9420CN User Manual

WARNING
■
For protection against the risk of electrical
shock, always disconnect all cables from
the wall outlet before servicing, modifying
or installing the equipment.
■
This equipment may not be used on coin
service lines provided by the telephone
company or connected to party lines.
■
Brother cannot accept any financial or other
responsibilities that may be the result of
your use of this information, including
direct, special or consequential damages.
There are no warranties extended or
granted by this document.
■
This machine has been certified to comply
with FCC standards, which are applied to
the USA only. A grounded plug should be
plugged into a grounded AC power outlet
after checking the rating of the local power
supply for the machine to operate properly
and safely.
Federal Communications
Commission (FCC)
Declaration of Conformity
(USA only)
Responsible Party:
Brother International Corporation
100 Somerset Corporate Boulevard
Bridgewater, NJ 08807-0911 USA
TEL: (908) 704-1700
declares, that the products
Product Name: MFC-9420CN
comply with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This
device may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may cause
undesired operation.
Important information
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
■
Reorient or relocate the receiving antenna.
■
Increase the separation between the
equipment and receiver.
■
Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
■
Call the dealer or an experienced radio/TV
technician for help.
Important
Changes or modifications not expressly approved
by Brother Industries, Ltd. could void the user's
authority to operate the equipment.
Important - about the interface cable
A shielded interface cable should be used to
ensure compliance with the limits for a Class B
digital device.
A
A - 2