Paper Settings; Banner Printing - Canon BJC-2000 Service Manual

BJC-2000

1.5 Paper Settings

For optimum printing, the printer has various paper settings to suit various types of
paper. Set the paper selection lever before loading the paper.
Media
Plain paper
High resolution paper
Envelopes
Transparencies
Back print film
Glossy photo paper
Banner paper
Fabric sheet
High gloss film

1.6 Banner Printing

When printing on banner paper, remove the paper support and set the paper delivery
flap to the upright position. To avoid misfeeding, put a light crease between the first
and second page and set the first page in the sheet feeder. Place the rest of the banner
paper behind the printer. Each top margin for banner printing is set at 0mm.
However, to avoid printing on the platen, printing will start 3mm from the initial top
margin. Set an extra sheet at the end in case the bottom edge is not printed on the
last page.
Banner printing uses a large amount of ink. To avoid ink shortage, use of a new ink
cartridge when printing banners is recommended.
Banner Paper
Paper Delivery Flap
Output Tray Extension
TABLE 3-1 QUICK REFERENCE FOR SETTING
Thickness Lever
Left
Left
Right
Left
Left
Left
Right
Right
Left
Figure 3-13 Banner Printing
Paper Feed
Method
Sheet feeder
Sheet feeder
Sheet feeder 5 envelopes
Sheet feeder
Sheet feeder
Sheet feeder
Sheet feeder
Sheet feeder
Sheet feeder
3-11
Part 3: Operating Instructions
Flap
Limit Position
5 mm Flat
5 mm Upright
Flat
20 sheets Upright
10 sheets Upright
1 sheet Upright
1 sheet Upright
1 sheet Upright
1 sheet Upright