Table of Contents
Advertisement
Part 3: Operating Instructions
The errors listed in Table 3-2 are described below.
· Recoverable errors by customers (Correctable by removing the paper and pressing
and holding down the RESET button for over two seconds).
1)
Paper feed
Occurs when the paper cannot be fed properly.
2)
Cover open
Occurs when the printer's front cover is open.
3)
Paper jam
Occurs when the printed paper cannot be ejected.
4)
No cartridge
Occurs when a BJ cartridge is not installed.
5)
Head mismatch
Occurs when the scanning operation is attempted with a BJ cartridge installed.
Occurs also when attempting printing with a scanner cartridge installed.
· Unrecoverable errors by customers (Pull out the AC plug to turn off the power.)
6)
Home position error
Displayed when the home position can not be detected.
7)
Carriage control error
Occurs when the print position correction cannot be detected.
8)
Head temperature (sensor) error
Occurs when the diode sensor in the BJ cartridge head is assessed as irregular.
9)
Printer temperature sensor error
Occurs when the temperature sensor's (TH1) reading on the control board is
irregular.
10) No cartridge error
Occurs when the printer does not detect the cartridge other than during cartridge
replacement.
11) Waste ink full error
Occurs when the "total waste ink amount" recorded by the EEPROM exceeds the
prescribed limit.
12) Purging operation error
Occurs when the purging operation detection at the capping position is irregular.
13) Scanner cartridge error
Occurs when the scanner cartridge is recognized but the scanner ID is incorrect.
Occurs when the calibration data sent from the computer is incorrect.
3-16
BJC-2000
Advertisement
Table of Contents
