IBM 9228 - IntelliStation Z - Pro Service Manual page 70

To remove a simple-swap drive in bay 4, 5, 6, or 7 complete the following steps.
Figure 27. Removing a simple-swap hard disk drive
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the computer and all attached devices; then, disconnect all external
3. Unlock the side cover. The bezel will not disengage from the computer if the
4. Remove the lower bezel (see "Removing the two-piece bezel" on page 33).
5. Pull the loops of the drive assembly that is to be removed toward each other;
6. If you are instructed to return the drive, follow all packaging instructions, and
Installing a simple-swap drive in bay 4, 5, 6, or 7
This procedure applies to a computer that has simple-swap hard disk drives.
Some models come with simple-swap SATA or SAS hard disk drives, which are
accessible from the front of the computer. Before you install a simple-swap SATA or
SAS hard disk drive, read the following information:
v Read the documentation that comes with the hard disk drive for cabling
v You can install four simple-swap SATA or SAS hard disk drives in the computer.
52
IBM IntelliStation Z Pro Type 9228 and 9232: Problem Determination and Service Guide
on page 29.
cables and power cords.
cover is locked. You do not have to remove the side cover.
then, pull the assembly out of the bay.
use any packaging materials for shipping that are supplied to you.
instructions.
Drives are installed starting in bay 4. Additional drives are then installed in bays
5, 6, and 7.
To install a simple-swap hard disk drive, complete the following steps.