IBM 9228 - IntelliStation Z - Pro Service Manual page 118

Table 7. POST error codes (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 3, "Parts listing, Type 9228 and 9232," on page 19 to determine which components are
customer replaceable units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
trained service technician.
Error code Description
662 A diskette drive configuration error occurred. 1. Run the Configuration/Setup Utility program and
1162 The serial port configuration conflicts with
another device in the system.
11xx A system board serial port 1 error occurred
(xx can be any number or letter).
1601 A BIOS code update is required.
1762 A hard disk drive configuration error
occurred.
100
IBM IntelliStation Z Pro Type 9228 and 9232: Problem Determination and Service Guide
Action
diagnostics.
2. Reseat the diskette drive cable.
3. Replace the following components one at a time,
in the order shown, restarting the computer each
time:
a. Diskette drive cable
b. Diskette drive
c. (Trained service technician only) System board
1. Make sure that the interrupt request (IRQ) and I/O
port assignments needed by the serial port are
available.
2. If all interrupts are being used by adapters, remove
an adapter to make an interrupt available to the
serial port, or force other adapters to share an
interrupt.
3. Make sure that the serial port setting is correct in
the Configuration/Setup Utility program. If the
setting is not correct, change it and save the
settings.
4. (Trained service technician only) Replace the
system board.
1. Run the Configuration/Setup Utility program.
2. (Trained service technician only) Replace the
system board.
1. Download and install the latest level of the BIOS
code.
2. (Trained service technician only) Replace the
system board.
1. Make sure that the hard disk drive is set correctly
in the Configuration/Setup Utility program.
2. Reseat the hard disk drive cable.
3. Replace the following components one at a time,
in the order shown, restarting the computer each
time:
a. Hard disk drive
b. Hard disk drive cable
c. (Trained service technician only) System board