IBM 9228 - IntelliStation Z - Pro Service Manual page 124

Table 7. POST error codes (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 3, "Parts listing, Type 9228 and 9232," on page 19 to determine which components are
customer replaceable units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
trained service technician.
Error code Description
00180600 PCI device built-in self test failure, PCI
bridge error.
00180700 PCI device not responding.
00180xxx The PCI adapter has requested resources
that are not available.
00181000 General PCI error.
106
IBM IntelliStation Z Pro Type 9228 and 9232: Problem Determination and Service Guide
Action
1. Run the Configuration/Setup Utility program.
2. Reseat each adapter.
Note: If an error LED is lit on an adapter, reseat
that adapter first. If no LEDs are lit, reseat each
adapter one at a time, restarting the computer
each time to isolate the failing adapter.
3. Replace the following components one at a time,
in the order shown, restarting the computer each
time:
a. Failing adapter
b. (Trained service technician only) System board
1. Run the Configuration/Setup Utility program, select
Devices and I/O Ports, and make sure that the
device is enabled.
2. Reseat each adapter.
Note: If an error LED is lit on an adapter, reseat
that adapter first; if no LEDs are lit, reseat each
adapter one at a time, restarting the computer
each time, to isolate the failing adapter.
3. Replace the following components one at a time,
in the order shown, restarting the computer each
time:
a. Failing adapter
b. (Trained service technician only) System board
1. Reorder the adapters in the PCI slots.
2. Make sure that the boot device is positioned early
in the scan order so that it is executed by POST.
3. Make sure that all adapters are set correctly in the
Configuration/Setup Utility program, changing
memory settings if necessary.
4. Remove an adapter to make more memory
available to the adapters.
5. Disable the BIOS on the adapter (see the
documentation that comes with the adapter).
6. (Trained service technician only) Replace the
system board.
1. Replace the following components one at a time,
in the order shown, restarting the computer each
time:
a. Adapter
b. (Trained service technician only) System board