3 ] Removing The Frame Assy - Brother P-touch PT-1180 Service Manual

[ 3 ] Removing the frame ASSY
(1) Remove the two motor harnesses from the sub PCB by melting the solder.
(2) Remove the three screws and remove the frame ASSY from the bottom cover.
Note: The cutter lever will be disconnected from the cutter lever shaft of the frame Assy at this
point.
Frame ASSY
Bottom cover
FG harness
Screws
Fig. 2.2-5 Removing the Frame ASSY
Melting the solder
Melting the solder
II-10
Upper cover