7 ] Installing The Cutter Case Assy, Board And The Bottom Cover - Brother P-touch PT-1180 Service Manual

[ 7 ] Installing the cutter case ASSY, board and the bottom cover
(1) Hold the bottom cover as shown below, then connect the thermal head flat cable to the main
PCB through under the motor harness and the power supply harness connector.
(2) Place the upper and bottom cover upside down. And secure the bottom cover by four
screws.
Tightening torque: 0.39 N . m (4 kg . cm)
(3) The cutter case ASSY and board are inserted into the frame ASSY.
Note: When setting the bottom cover with upper cover, care must be taken so that the cable and
harness are not caught between them.
Upper cover
Fig. 2.2-27 Installing the Bottom Cover (1)
Screws
Fig. 2.2-28 Installing the Bottom Cover (2)
Screw
Board
II- 25
Thermal head flat cable
Bottom cover
Cutter case ASSY
Screw
Bottom cover