4 ] Removing The Chassis Assy - Brother PT-1800 Service Manual

[ 4 ] Removing the Chassis ASSY

During the following job, handle the connectors and harnesses gently so as not to
damage them.
(1) Remove the screw that secures the anti-static lead wire to the chassis.
(2) Disconnect the thermal head cable from the main PCB.
• Before pulling the cable , be sure to unlock the connector on the main PCB.
(3) Disconnect the drive motor harness from the main PCB.
(4) Disconnect the cassette sensor cable from the main PCB.
• Before pulling the cable , be sure to unlock the connector on the main PCB.
(5) Take off the cassette cover from the body cover. The roller release lever will pop up
(when viewed from the bottom).
(6) Lift the chassis ASSY up and out of the body cover.
(7) Remove the cutter lever.
Figure 2.2-5 Removing the Chassis ASSY
II - 11